Part Number: SNO-2110-BRD

Description: Stage 2 Vehicle Specific Boost Cooler

Fitment: 15-21 Subaru STI 2.5L

Notes: Not for sale in California not CARB Legal

Details:

The Stage 2 Boost Cooler® progressively commands injection based off of boost pressure (PSI). Start & full points are adjustable directly on the screen to match what the engine is producing. The VC-50 allows the user to see boost increase as well as injection take place at the desired boost levels. This is the preferred method of injection for turbos and centrifugal superchargers. Injection will take place inside the throttle body spacer injection plate and deliver a finally atomized mix of water-methanol into the engine.

The all new Snow Performance Stage 2 Boost Cooler® is the only water-methanol injection system tailored to your 2004-2016 Subaru WRX STI. Unlock 50-70+HP on your vehicle while decreasing your air temps by up to 100 degrees! Increase your pump gas octane by 25 points and make more power efficiently with a cooler running motor! The Stage 2 uses a progressive controller that proportionally injects more or less according to boost pressure. Start and full points are adjustable for engagement and delivery curve to match what the engine requires. Proportionally injecting according to boost pressure gives an accurate delivery of water-methanol and allows cooling and performance improvements over a wide range for improved drivability.

New for 2016 The Stage 2 introduces the VC-50 Controller. The VC-50 offers the functionality of a boost gauge and water-methanol controller all in one! Highlighting a 7 color (Blue, White, Red, Yellow, Orange, Purple, Green) OLED screen displaying boost, percentage of injection, low level, secondary nozzle activation, prime button, and 2 fault codes directly on the screen. Equipped with STI throttle body spacer plate you can now mount up to two water-meth nozzles in a clean custom package.

Kit Includes:
300 PSI Ultra High Output Pump
3 Quart Reservoir
All Tubing Necessary for Install - 25ft of 1/4in High Temp Nylon Tubing, 36in High Pressure Boost Line, 3ft Black Wire Loom
Progressive VC-50 Controller
2 1/16 Gauge Pod
Pig Tail Harness
Level Switch Upgrade
1 Nozzle Holder/Check Valve Combo
Solenoid Upgrade
STI Throttle Body Spacer Injection Plate - 2 1/8in NPT Ports
2 Throttle Body Spacer Injection Plate Gasket
3 Hyper-Sonic Nozzles
Required Hardware Needed for Install
Snow Performance Running S Decal
Comprehensive Instructions to Install on Any Forced Induction Vehicle
Snow Performance 1 Year Warranty